Effect of Sputtering Pressure on the Structural and Optical Properties of ZnO Films Deposited on Flexible Substrate

Category: Research Articles Published: Wednesday, 22 June 2016

Effect  of  Sputtering  Pressure  on  the  Structural and Optical  Properties of  ZnO  Films  Deposited on Flexible Substrate

Lam Mui Li*, Azmizam  Manie @ Mani,  Farah Lyana Shain,  Afishah Alias, Saafie Salleh

Faculty  of  Science  and  Natural  Resources,  Universiti  Malaysia  Sabah 88999, Kota Kinabalu, Sabah, Malaysia

Corresponding author: This email address is being protected from spambots. You need JavaScript enabled to view it.

Zinc  Oxide  (ZnO)  has  get  attention  because  of  its  excellent  optical  transmittance approximately  ~80%.  A  systematic  study  has  been  made  of  the  effect  of  sputtering pressure on the structural and optical properties of the deposited ZnO films. ZnO thin films were deposited on plastic substrate by RF powered magnetron sputtering using ZnO disk with 99.99% purity. The RF power of 100 W and argon gas flow from 10 - 30 sccm was used to perform the sputtering process. The argon sputtering pressure was varied between 3 mTorr to 11 mTorr and the growth time is constant at 25 minute. The deposited ZnO thin films are characterized structurally and optically. Structural analysis using X-Ray Diffraction (XRD) show that all the films exhibit a (002) preferential orientation and the estimated grain size measured was varied from 24.5 nm to 29.8 nm.  Surface Profilometer was used to measure the thickness and RMS of the deposited films where the thickness decrease from 900 nm to 600 nm and the root mean square (RMS) roughness increase from 4.97 nm to 11.45 nm. The optical transparency value that achieved from UV-Vis Spectrometer is over 80% in the visible range and the band gap energy is within 3.27 eV-3.29 eV range.

  • The variation of full width at half maximum (FWHM) and estimated grain size ofZnO (002) diffraction peak at different sputtering pressure (b) Plot of graph(
Hits: 1271